LVDS IPS High Brightness TFT LCD Display 10.1 inch with PCAP - RFH1010J-AYH-LNB
LVDS IPS High Brightness TFT LCD Display 10.1 inch with PCAP - RFH1010J-AYH-LNB

LVDS IPS High Brightness TFT LCD Display 10.1" with PCAP

Model No. RFH1010J-AYH-LNB

RFH1010J-AYH-LNB is a TFT LCD display with IPS (In-Plane-Switching Liquid Crystal) panel; this IPS technique allows viewers to view the screen from wider angles. This 10.1-inch, 1024x600 pixels, 16:9 aspect ratio TFT module features high brightness 900 cd/㎡. It has built-in driver IC K79001HN and EK73215BCGA supporting LVDS interface. RFH1010J-AYH-LNB is a TFT module with PCAP touch allowing 5-point touch. The built-in IC for PCAP is ILI2511 which supports USB and I2C interfaces. The module works within temperature from -20~+70°C; storage temperature ranges from -30~+80°C.

Inquiry or Demo Code Datasheet Back Previous Next
  • General Specs
  • Interface Pin Function
  • Contour Drawing
  • Absolute Maximum Ratings
  • Electrical Characteristics
Item Dimension Unit
Size (Diagonal) 10.1 inch
Dot Matrix / Resolution 1024 × RGB × 600 dots
Module Dimension 235(W) × 143(H) × 8.78(D) mm
View Area 223.72 × 126.28 mm
Active Area 222.72 × 125.28 mm
Dot / Pixel Pitch 0.2175 × 0.2088 mm
LCD Type TFT, Normally Black, Transmissive
View Direction IPS
Viewing Angle 85/85/85/85
Aspect Ratio 16:9
Backlight Type LED, Normally White
Control-Board No
TFT Driver IC EK79001HN + EK73215BCGA or equivalent
Interface LVDS
PCAP FW Version V6.0.0.0.62.90.1.2
PCAP IC ILI2511 or equivalent
PCAP Interface USB (I2C available)
Detect Points 5 Points
Touch Panel Projected Capacitive Touchscreen, PCAP
Surface Glare
Brightness 900 cd/㎡
Frame Through Hole No
Operating Temperature -20~+70 °C
Storage Temperature -30~+80 °C
TFT Series High Brightness TFT, IPS TFT LCD, LVDS TFT LCD Display

TFT LCD MODULE

Pin No. Symbol Description
1 VCOM Common voltage
2 VDD Digital power
3 VDD Digital power
4 NC Not connect
5 Reset Global reset pin. Active low to enter reset state. Suggest to connecting with an RC reset circuit for stability. Normally pull high. (R=10KΩ,C=1μF)
6 STBYB Standby mode, normally pull high STBYB=”1”, normal operation STBYB=”0”,timing control, source driver will turn off, all output are high-Z
7 GND Digital ground
8 RXIN0- Negative LVDS differential data inputs
9 RXIN0+ Positive LVDS differential data inputs
10 GND Digital ground
11 RXIN1- Negative LVDS differential data inputs
12 RXIN1+ Positive LVDS differential data inputs
13 GND Digital ground
14 RXIN2- Negative LVDS differential data inputs
15 RXIN2+ Positive LVDS differential data inputs
16 GND Digital ground
17 RXCLKN- Negative LVDS differential clock inputs
18 RXCLKN+ Positive LVDS differential clock inputs
19 GND Digital ground
20 RXIN3- Negative LVDS differential data inputs
21 RXIN3+ Positive LVDS differential data inputs
22 GND Digital ground
23 NC Not connect
24 NC Not connect
25 GND Digital ground
26 NC Not connect
27 NC Not connect
28 SELB 6-bit/8-bit input select SELB = L , 8-bit ; SELB = H , 6-bit
29 AVDD Analog power
30 GND Digital ground
31 LED- LED Cathode
32 LED- LED Cathode
33 L/R Left or right display control
34 U/D Up / down display control
35 VGL Negative power for TFT
36 NC Not connect
37 NC Not connect
38 VGH Positive power for TFT
39 LED+ LED Anode
40 LED+ LED Anode

When L/R=”0”,set right to left scan direction.
When L/R=”1”,set left to right scan direction.
When U/D=”0”,set top to bottom scan direction.
When U/D=”1”,set bottom to top scan direction.

PCAP PIN Definition

Pin Symbol Function
1 USB_VSS System ground
2 USB_VDD 5V Power supply
3 USB_D+ Data +
4 USB_D- Data -
5 VSS System ground
6 SDA I2C data input and output
7 SCL I2C clock input
8 RST External Reset, Low is active
9 INT External interrupt to the host
10 VDDT 3.3 Power supply

LVDS IPS High Brightness TFT LCD Display 10.1 inch with PCAP - RFH1010J-AYH-LNB

Item Symbol Min Typ Max Unit
Operating Temperature TOP -20 +70
Storage Temperature TST -30 +80

Typical Operation Conditions (At Ta = 25 °C,)

Item Symbol Min Typ Max Unit
Digital Power Supply Voltage For LCD VDD 3 3.3 3.6 V
Analog Power Supply Voltage AVDD 9.89 10.2 10.5 V
Gate On Power Supply Voltage VGH 19.4 20.0 20.6 V
Gate Off Power Supply Voltage VGL -10.3 -10.0 -9.7 V
Common Power Supply Voltage VCOM 4.0 4.3 4.6 V
Input logic high voltage VIH 0.7 VDD - VDD V
Input logic low voltage VIL 0 - 0.3 VDD V
Supply PCAP USB_VDD 5V 4.4 5.0 5.5 V
I VDD 5V 97.8 120 mA
Top