| Pin No. |
記号 |
I/O |
ご説明 |
| 1 |
NC |
|
Do not connect with other NC pins |
| 2 |
GDR |
O |
N-Channel MOSFET Gate Drive Control |
| 3 |
RESE |
I |
Current Sense Input for the Control Loop |
| 4 |
NC |
NC |
Do not connect with other NC pins |
| 5 |
VSH2 |
C |
Positive Source driving voltage(Red) |
| 6 |
TSCL |
O |
I2C Interface to digital temperature sensor Clock pin |
| 7 |
TSDA |
I/O |
I2C Interface to digital temperature sensor Data pin |
| 8 |
BS1 |
I |
Bus Interface selection pin |
| 9 |
BUSY |
O |
Busy state output pin |
| 10 |
RES# |
I |
Reset signal input. Active Low. |
| 11 |
D/C# |
I |
Data /Command control pin |
| 12 |
CS# |
I |
Chip select input pin |
| 13 |
SCL |
I |
Serial Clock pin (SPI) |
| 14 |
SDA |
I/O |
Serial Data pin (SPI) |
| 15 |
VDDIO |
P |
Power Supply for interface logic pins It should be connected with VCI |
| 16 |
VCI |
P |
Power Supply for the chip |
| 17 |
VSS |
P |
Ground |
| 18 |
VDD |
C |
Core logic power pin VDD can be regulated internally from VCI. A capacitor should be connected between VDD and VSS |
| 19 |
VPP |
P |
FOR TEST |
| 20 |
VSH1 |
C |
Positive Source driving voltage |
| 21 |
VGH |
C |
Power Supply pin for Positive Gate driving voltage and VSH1 |
| 22 |
VSL |
C |
Negative Source driving voltage |
| 23 |
VGL |
C |
Power Supply pin for Negative Gate driving voltage VCOM and VSL |
| 24 |
VCOM |
C |
VCOM driving voltage |