8 TFT with TFT LCD Controller Board - Raystar Display - RFF800P-1IW-DBN
8 TFT with TFT LCD Controller Board - Raystar Display - RFF800P-1IW-DBN
  • General Specs
  • Interface Pin Function
  • Contour Drawing
  • Absolute Maximum Ratings
  • Electrical Characteristics
Item Dimension Unit
Size 8 inch
Dot Matrix (Resolution) 800 × RGB × 480 (TFT) dots
Module Dimension 192.8(W) × 116.9(H) × 13.1(D) mm
View Area 180.1 × 103.4 mm
Active Area 176.64 × 99.36 mm
Dot Pitch 0.0736 × 0.2070 mm
LCD Type TFT, Normally White, Transmissive
View Direction 12 o’clock
Gray Scale Inversion Direction 6 o’clock
Backlight Type LED, Normally White
Control-Board Yes
Bulit-in Controller RA8875
Interface Digital 8080 family MPU
Touch Panel Without Touch Panel
Surface Anti-Glare
Brightness 450 cd/㎡
Frame Through Hole No
Operating Temperature -20~70 °C
Storage Temperature -30~80 °C
TFT Series TFT Panel with Controller Board

LCM PIN Definition

TFT LCD Panel Driving Section
FPC Connector is used for the module electronics interface.

Pin Symbol Function
1 GND System ground
2 VDD Power Supply : +3.3V
3 BL_E Backlight control signal , H: On \ L: Off
4 RS Data/Command select
5 WR Write strobe signal
6 RD Read strobe signal
7 DB0 Data bus
8 DB1 Data bus
9 DB2 Data bus
10 DB3 Data bus
11 DB4 Data bus
12 DB5 Data bus
13 DB6 Data bus
14 DB7 Data bus
15 DB8 Data bus
16 DB9 Data bus
17 DB10 Data bus
18 DB11 Data bus
29 DB12 Data bus
20 DB13 Data bus
21 DB14 Data bus
22 DB15 Data bus
23 WAIT Wait Signal Output(H:active)
24 NC No connection
25 CS Chip select
26 RESET Hardware reset
27 LR Left / right selection; Default L/R=H
28 UD Up/down selection; ; Default U/D=L
29 NC No connection
30 NC No connection
31 NC No connection
32 NC No connection
33 VLED- Power for LED backlight cathode(GND)
34 VLED- Power for LED backlight cathode(GND)
35 VLED+ Power for LED backlight anode(+5V)
36 VLED+ Power for LED backlight anode(+5V)

8 TFT with TFT LCD Controller Board - Raystar Display - RFF800P-1IW-DBN

Item Symbol Min Typ Max Unit
Operating Temperature TOP -20 +70
Storage Temperature TST -30 +80

Operating conditions (CON2.Pin1=GND, Pin2=VDD)

Item Symbol Condition Min Typ Max Unit
Supply Voltage For LCM VDD 3.0 3.3 3.6 V
Supply Current For LCM IDD 199 300 mA

Backlight driving conditions (CON2.Pin33,34=VLED-, Pin35,36=VLED+)

Parameter Symbol Min Typ Max Unit
Operation Current For LED Driver VLED=5V 600 900 mA
Power Consumption VLED=5V 3000 4500 mW
Supply Voltage For LED Driver VLED+ 5 V
LED Life Time 20,000 Hr
Top